Principles of Operation

September 14, 2008 · Filed Under Pellet Stove Operation 

A pellet stove will normally consists of these six basic components in some form:

  • A hopper
  • An auger system
  • Two blower fans (combustion and convection)
  • A firebox (with refractory panels, burn-pot, and ash collection system)
  • Various safety features (vacuum switch, heat sensors)
  • A main control box/board (or “brain”)

For pellet stoves to properly function they require electricity which can be plugged into a normal wall outlet. A pellet stove is a consistent heater consuming fuel that is fed evenly from a refillable hopper into the burn-pot (a perforated cast-iron basin), through a motorized system. The most commonly tpye of distributor used is called an auger, the system consists of a spiral length of metal encased in a tube. This mechanism is either located above the burn-pot or slightly beneath and guides a portion of pellet fuel from the hopper upwards until it falls into the burn-pot and begins to combust.

A fan systems is used for clean, economical performance. The flame produced is concentrated and intense as a combustion blower introduces air into the bottom of the burn-pot. Previously some pellet stoves were hot to the touch (especially on the viewing window), most manufacturers now utilize a series of cast-iron heat exchangers that run inside of thefirebox.

The first is a convection blower which  are used to circulate the room air through the heat exchangers and redirected back into the living space. This method allows for a much higher efficiency than the radiant heat of a hand-fed wood or coal stove, and this will cause the top of the pellet stove to be not more than warm to the touch. The other fan used is for convection air, an exhaust fan forces air from the firebox through special venting specifically made for pellet fuel. This cycle of circulation is an integral part of the combustion system as well, for the concentrated high-temperature flame will quickly overheat the firebox. Some of the possible problems associated with overheating are electrical component failure and flames traveling into the auger tube causing a hopper fire. All pellet stoves have built in heat sensors for safe guards so any unsafe conditions occur it will shut down.

Starting pellet stoves can either be lit manually or through an automatic igniter. The igniter piece resembles a car’s electric cigarette lighter heating coil. Most models have automatic ignition and can be readily equipped with thermostats or remote controls.

Related Posts

  • Other factors for Venting System for Pellet stoves
    • Besides appliance requirements, what other factors may be considered in specifying pellet venting systems? The following factors may play a role
  • Pellet Stove Shut Down Operation
    • What are signs of performance problems? Properly operated and well maintained pellet stoves experience few, if any problems. Most of pellet
  • Pellet Stove Starting Operation
    • Where do we start? The obvious would be the instructions that accompany the pellet stove appliance, generally operating a pellet stove
  • Wood Pellet Stove FAQ
    • How do I start my fire? If you have a manual igniter you need to use a special gel or solid
  • Whitfield Winslow Pellet Stove
    • The Winslow pellet stove by Whitfield delivers reliable heat in an attractive style that can be customized to complement any

    Below are a few recommended Products:

    If you found this page useful, consider linking to it.
    Simply copy and paste the code below into your web site (Ctrl+C to copy)
    It will look like this: Principles of Operation

    Tags:

    Comments

    3 Responses to “Principles of Operation”

    1. Blog Carnival Edition No. 8 - A Carnival of Everything Home | My DIY Home Tips on October 7th, 2008 5:13 pm

      [...] presents Principles of Operation posted at Pellet Stove [...]

    2. Rosemary on October 7th, 2008 5:23 pm

      Linked at http://mydiyhometips.com/2008/10/07/blog-carnival-edition-no-8-a-carnival-of-everything-home/

    3. Ben Dinsmore on October 7th, 2008 6:40 pm

      Simon,

      Great information here about pellet stoves. They are becoming more and more popular here in Maine especially with the price of oil as high as it has been!

      I will certainly be doing some linking to your site in some upcoming articles I am writing on economical ways to reduce your homes energy use!

    Leave a Reply